Problem with Danitta
3 posters
Page 1 of 1
Problem with Danitta
While using my cb yesterday, it went crazy on me, the channel stations went mad, scrolling through all of the stations on its own, therefore not holding at any station at all, any idea's
oggi240- New Member
- Location : kent
Registration date : 2010-05-31
Number of posts : 2
Points : 4
Reputation : 0
Re: Problem with Danitta
My guess is a dirty connection? Do you have an up/dwn on the mike?
simon007- Admin
- Location : Home
Registration date : 2007-10-04
Number of posts : 1612
Points : 820
Reputation : 121
Re: Problem with Danitta
Checked all connections and they are fine, the problem seems to come from the 6 pin plug on the front, when i connect it to the unit the stations run wild, and when i disconnect it the station numbers are fine, i took the 6 pin apart cleaned and stripped all the old solder, reconnected it all with new solder left the outer cover of and it worked fine, put on the outer cover / shroud, and it goe's on the blink again. so now feed up and leaving it alone until another day.
oggi240- New Member
- Location : kent
Registration date : 2010-05-31
Number of posts : 2
Points : 4
Reputation : 0
Re: Problem with Danitta
Sounds like a possible short, look carefully at how the outer cover fits & also very carefully at where it grips the microphone cable, that's a common area for problems as it takes a lot of wear & tear.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|