Modification for KLV350 Linear required.
Page 1 of 1
Modification for KLV350 Linear required.
by Guest Sat Dec 01, 2007 2:07 pm
Having recently purchased a KLV350 Linear amplifier quite cheaply, I tried using it on the FT857D , with the homebrew antennas that go into the ATU.
The plate tuning on the amp creates a massive miss match between tuning the linear and the SWR on the ATU.
As I dont want to burn the PA section out I have not bothered to connect the Linear again.
However, I guess it will work AOK on my Ranger VR900 radio.
Is there a modification that can be done to the KLV350 linear to make it more compatable to the FT857D remember that I only want a linear on the 11M band.
If so , would it be a costly modification?
Should I just leave it to use on the VR900 as is. ......... Would a matcher in line help create a ballence between the two lots of tuning?
The plate tuning on the amp creates a massive miss match between tuning the linear and the SWR on the ATU.
As I dont want to burn the PA section out I have not bothered to connect the Linear again.
However, I guess it will work AOK on my Ranger VR900 radio.
Is there a modification that can be done to the KLV350 linear to make it more compatable to the FT857D remember that I only want a linear on the 11M band.
If so , would it be a costly modification?
Should I just leave it to use on the VR900 as is. ......... Would a matcher in line help create a ballence between the two lots of tuning?
Guest- Guest
Similar topics» HARVARD 410T MODS REQUIRED
» RM Linear amps.
» mobile co-linear
» wanted rm kl 500 linear
» mobile linear amp
» RM Linear amps.
» mobile co-linear
» wanted rm kl 500 linear
» mobile linear amp
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|